Операция "Стоп" линии будет осущест

Операция "Стоп" линии будет осуществляться следующим образом.
Оператор будет в состоянии ускорить вниз линию по эксплуатации данного переключателя. Линия будет замедляться до мин. скорость (нулевая скорость), если оператор не переключатель «Hold», упомянутых выше.
"Run", "Hold" и "Стоп" смогут работать снова.
Величина замедления линии будет такой же, как в операционной установки скорости ,

결과 (영어) 1:

Operation "stop" line will be as follows. The operator will be able to accelerate down the line to operate this switch. The line will slow down to minutes. speed (zero speed), if the operator does not Hold switch mentioned above. "Run", "Hold" and "stop" will be able to work again. The deceleration will be the same as in the operating speed,

결과 (영어) 2:

Operation "Stop" line will be as follows.
The operator will be able to speed down the line by using this switch. The line will slow down to low. speed (zero speed), if the operator does not switch «Hold», mentioned above.
"Run", "Hold" and "Stop" can operate again.
The magnitude of the deceleration line is the same as the operating speed setting,

결과 (영어) 3:

The operation "Stop" line will be carried out as follows.
Agent will be in a position to accelerate down the line in the operation of the switch. Line will slow down to min. speed (zero speed),If the operator does not switch the "hold", referred to above.
"Run", "hold" and "Stop" will be able to work again.
Value slowing down the line will be the same as the operating speed set ,